GFC-501 Devilbiss Gravity Cup ( GFC-501 )

• Color : WHITE
• Size : 20 OZ
• Performance Level : BEST, BETTER
• Wet or Dry : DRY
• Cup Size : 20 OZ
• Case Quantity : 1 PC/BOX
• Brand : DEVILBISS

GFC-501 (acetal) 20 Oz. Cup This gravity feed cup is designed to work with the GFG, GFHV, GTI and FLG gravity feed spray guns and with or without the DeVilbiss disposable cup liner. The cup liner allows painting in any position and simplifies clean up. The cup is constructed from acetal which is easier to clean and resists stains better than nylon. This cup has a unique drip check lid to prevent paint from dripping out of the vent in the lid. It has a high grade stainless steel connector, compatible with waterbornes and all common coating materials.

INSTALLATION : Protective coatings have been used to protect the cup after manufacture. Flush all equipment with a suitable solvent before use to remove these coatings from the material passages.

ASSEMBLY OF CUP TO GUN : 1. Remove one of the cup gaskets (#3(White) for GFG and GFHV guns) (#3A (Blue) for GTI and FLG guns) from the poly bag.
                                              2. Place this cup gasket in the fluid inlet of the gun body. See Cup Drawings.
                                              3. Store remaining cup gasket in a safe place for future use.
                                              4. Place filter (4) in cup outlet at this time if desired. See Cup Drawings.
                                              5. Assemble cup to gun and tighten hand tight.

FILLING WITH PAINT : Fill the cup with paint to the bottom of the threads. Do not overfill.

INSTALLING THE LID : Place plastic lid on the top of the cup, and hand tighten. Fold vent cap and push onto center portion of lid (if vent cap is not already assembled).

PAINTING : This disposable liner allows you to spray in any position, even upside down. To spray upside down, you must first purge the air from the cup liner.

To purge air from cup liner : 1. Connect to proper air supply (minimum of 30 PSI)
                                              2. Turn cup upside down (See Figure below)
                                              3. Trigger gun until a constant paint flow is observed.

CLEANING 

Note: For routine cleaning, it is not necessary to remove cup from gun. Do not remove washer (3) from gun. If washer (3) is removed, it must be replaced.

Remove lid and properly dispose of any excess paint. Pour in a small amount of clean solvent. The amount will vary with different coatings and solvents. Reinstall lid. Shake cup to wash down the inside surfaces. Pull trigger to allow some solvent to be flushed through gun. Remove lid and pour out dirty solvent. Add a small amount of clean solvent and repeat procedure. Wipe exterior of cup and lid with a clean cloth and clean solvent.

If a paint filter was used in the bottom of the cup outlet, it should be removed and cleaned or replaced at this time.

User Reviews About This Products.